Rec Room 32" Sit Do...
 
Notifications
Clear all

Rec Room 32" Sit Down and Super PixelcadeLCD

1 Posts
1 Users
0 Reactions
877 Views
Pixelcade Admin
(@pixelcade-admin)
Reputable Member Admin
Joined: 6 years ago
Posts: 330
Topic starter  

This customer has the Rec Room 32" Sit down for which there is currently not a mount for. He was able to make it work however by doing the following. This isn't officially supported but sharing for reference.

"Took the 2 top screws out of each side to get the top off...but there are also wood dowels in there so I took out the back screw below the top on one side to get a little leverage, stuck a screwdriver in there to make room and cut the dowel out of one side so I can take the top off. Then I got the lcd part in the slot, ran the plug out of the back hole, centered it, and put the top back on. I lined up the rear screws on the top, the front are too high now so I rested it on top of the lcd and held it down so it was snug while I tightened the screws back in. The bottom 2 were a little tricky, I had to put some pressure to get them in but they fit. I tried pulling on it a bit and it wasn't moving but like I said I might get some black tape to fill in the sides and maybe secure it more. Lastly covered up the gaps in the sides with black painter's tape."

20210101 042043
20210101 043711
20210101 042028
20210101 042016
20201222 115414
20201221 202515
20201221 202503
This topic was modified 4 years ago by Pixelcade Admin

   
Quote
Proudly powered by Wpopal.com