On #1, I did send an email earlier to do a remote session there, I'd need to see the logs to see what is going on there. pixelcade companion in your...

oh that's great, that makes sense as if the board is not getting the required amount of voltage, the board will reset and you'll get a disconnect. You...

something to try, I've seen a few cases where USB 3 ports had issue so try another USB port, preferably a USB 2 one if you have

Popper and Pixelcade is somewhat new so could be some kinks. Can you share a video here of what is happening specifically, that'll be helpful to see t...

send a few sequences if you don't mind and will try and re-create on my end and also are you seeing this only in pixelcade companion or also from your...

@dulkenraad can you re-create it or it's random? If you can re-create, shoot me steps and will try on my end

yes correct, follow these instructions to set the default marquee, make sure the pixelcade listener is running at the time and use the Pixelcade 4.7.x...

not sure what is happening there. sorry, you'll need take that up with AtGames.

you can have both, just remove the Pixelcade Listener manually from your windows startup folder as that is not used for popper

also when using log file, just run pixelweb manually, no need to add that in autostart, just kill pixelweb before you run it manually (kill pid)

for the logfile, launch like this: pixelweb -logfile "anyname.log" -debug I'll need to dig into this when back from vacation in April

you can also use the logfile param and generate a logfile to see more info on what is happening

also make sure that the game has a corresponding PNG file, did you try other games? If the game only has a GIF , then that is what is supposed to happ...

here's the docs for RetroPie, see the Customizing Pixelcade Behavior in RetroPie section once you have the right command line that works with...

ok, so I know you are not on linux but see command lines are this page (towards bottom) those will work on windows too so you'll just need to add...