Pixelcade LED Install Guide for Rec Room Masters Xtension 32" Upright
Thank you very much for your business. These instructions will guide you how to install Pixelcade for your Rec Room Masters Cabinet. Follow the steps on this page if you have a Pixelcade LED marquee.
Click here if you have a Pixelcade LCD marquee.
Pixelcade LED Marquee Hardware Installation
IMPORTANT: For Pixelcade V1 boards (black board), use only the included 5V, 10A power supply. Using an incorrect power supply such as 12V will destroy Pixelcade LED.
For Pixelcade V2 boards (purple board), use the included 12V, 5A power supply or Pixelcade SATA power cable.
The video below will guide you how to install Pixelcade LED in your Rec Room Masters 32″ Upright Cab.
Once finished, then refer to the Pixelcade software installation steps below.
Pixelcade Software Installation
After installing your marquee, next install the Pixelcade software. The Pixelcade software enables your supported arcade front end (CoinOps, HyperSpin, Launch Box / Big Box, RetroBat, Game Ex, MiSTer FPGA, RetroPie, Batocera, and EmuELEC) to communicate with your Pixelcade LED marquee.
Click Here for Windows Based Front Ends
or
Click Here for RetroPie on Raspberry Pi
or
or
or
Optional : Pixelcade LED also doubles as a Pinball DMD if you are on Windows and using Virtual Pinball, Pinball FX2 (Steam only), or Pinball FX3 (Steam only). Click here for Pinball DMD setup instructions
Optional: LED Art Pack (Paid)